
DMX (digital multi-channel signal control) is usually used in stage lighting, architectural lighting, and other places. The DMX terminal resistor is the resistor that connects the positive and negative signals of the DMX data at the end of the DMX signal cable (the second and third pins of the five-core card dragon plug). In long-distance DMX signal transmission, the terminal resistor helps to maintain the integrity of the signal, reduce the signal attenuation caused by the loss during cable transmission, and ensure that the receiving end can receive the signal. If there is no terminal resistor, when the signal is transmitted to the end, part of the signal will be reflected to the signal source along the original cable path. This may cause the reflected signal to offset the original DMX signal, interfere with the system, and cause malfunctions. Installing a DMX terminal resistor at the end of the signal cable can "absorb" the signal at the end of the transmission line and prevent the reflection of the signal.
The commonly used DMX terminal resistors are generally between 100 and 200 ohms (1/4 watt), and 120 ohms (1/4 watt) resistors can be selected in most cases.
1. Connection method of DMX terminal resistor when there is no splitter amplifier:
There is only a dimmer (silicon box) in the circuit, and the connection method is as follows: (silicon box and dimming console)
Insert a five-core male plug of Caron into the DMX THRU port of the last silicon box, and weld a 120-ohm resistor on the 2nd and 3rd pins inside the male plug. Other silicon boxes do not need to use terminal resistors.

DMX signal cables cannot be connected in a "Y" shape, that is, two DMX signal cables are not allowed to be led out from the same DMX output port of a console. In order to make the dimming system work better, one DMX signal cable can be connected to 8 to 10 silicon boxes, and a 120-ohm terminal resistor is connected to the last silicon box.

2. Connection method of DMX terminal resistor when adding a DMX splitter amplifier
When using one signal cable cannot meet the needs, a DMX splitter amplifier should be used. After receiving the DMX signal, the DMX splitter amplifier outputs 4 DMX signals, and the input and output are isolated. A 120 Ω resistor has been soldered to the interface for receiving DMX signals inside the DMX splitter amplifier. However, the four outputs of the splitter amplifier are four independent DMX signal cables, and a 120 Ω terminal resistor should be added to each of their signal termination points.

Premier Cabel provides you with DMX terminal resistor connectors for lighting control systems and connection cables for lighting fixtures. OEM/ODM services are available. For details, please contact the staff email below.

